ROBOT LASER PROJECT | |||||||||||||||||||||||||||||||||||||||||||||||||
Last Stable version is last fully tested version, in any case can not be guaranteed bug free. to be copied to the installation folder overwriting the old files (ALWAYS
do a backup before). To register the program, follow the instructions at startup, or by the Info button (Question Mark) Order to prevent the email request is misidentified as spam, please generate the email request using the appropriate button.
The license is tied to disk where it is installed RobotLaser, if you want to use the program on more than one PC, just install the program on removable disk (USB stick etc.)
(Always make a backup of the license, another copy will not release out of the beta phase).
Sometimes can happen that the installation of the license fails (for policy or PC antivirus, or other) Will be necessary delete the old license through LicenseKiller program, to be activated with a password be requested by email. NO MORE NECESSARY from ver 0.6.0
Now is possible to use MARLIN Firmware to drive a 3D printer with laser in place of extrusor. Is also possible to install a milling cutter -> MiniCNC It will soon be available a version of GRBL for Arduino Uno + RAMPS 1.4 hardware.
NOTE Take a look on the Benbox Laser DIY Machines Forum : *) Genesis of a Laser Controller *) DXF Import
|
|
||||||||||||||||||||||||||||||||||||||||||||||||
Known Bugs:
|
ChageLog:
|
||||||||||||||||||||||||||||||||||||||||||||||||
Please email me at: robotlaser@robot-eyes.com |